Using SCRT with Ledger
Note: This guide is for Ledger Nano S but according to community members it also works for Ledger Nano X.
- This guide assumes you have a verified, genuine Ledger Nano S device.
- If you don't, or you using your Ledger device for the first time, you should check Ledger's Getting Started guide.
- We also advise you to check your Ledger's genuineness and upgrade your firmware to the newest one available (
- Have a machine with Ledger Live installed.
- Have the latest version of our latest binaries installed. You can get it here .
Install Cosmos Ledger App
- Open Ledger Live and go to Settings (gear icon on the top right corner):
- Enable developer mode:
- Now go to Manager and search "Cosmos":
- Our binaries require Cosmos App Version
1.5.1(if you only see a lower version available, like
1.0.0, then you need to upgrade your Ledger firmware).
- Hit "Install" and wait for the process to complete.
These are some basic examples of commands you can use with your Ledger. You may notice that most commands stay the same, you just need to add the
Note: To run these commands below, or any command that requires signing with your Ledger device, you need your Ledger to be opened on the Cosmos App:
Prepare your Linux host to work with ledger
Some users may not have their ledger recognized by their Linux host. To fix this issue implement the fix for connection issues on Linux from the ledger support page
wget -q -O - https://raw.githubusercontent.com/LedgerHQ/udev-rules/master/add_udev_rules.sh | sudo bash
Create an account
Note: You can use any number you'd like for your account number. Be sure to remember the number you used, so you can recover if needed.
secretcli keys add <account name> --ledger --account <account number on your Ledger>
Please backup the mnemonics!
Display your account address
secretcli keys show -a <account name>
Add an account to
secretcli that already exists on your Ledger
You'll use this when you, say, using a different machine.
secretcli keys add <account name> --ledger --account <account number on your Ledger> --recover
Note! If you run the above command without the
--ledger flag, the CLI will prompt you to enter your BIP39 mnemonic, which is your Ledger recovery phrase. YOU DO NOT WANT TO DO THIS. This will essentially save your private key locally.
Note: the commands below assume that you run them on the same machine where you have an Secret Network node running. However, if you need to connect to a remote Secret Network node (on the cloud) while you interact with your Ledger wallet locally, you will need to append the following to each command below:
secretcli tx send <account name or address> <to_address> <amount> --ledger
Delegate SCRT to a validator
secretcli tx staking delegate <validator address> <amount to bond> --from <account key> --gas auto --gas-prices <gasPrice> --ledger
Collect rewards and commission
secretcli tx distribution withdraw-all-rewards --from <account name> --gas auto --commission --ledger
Vote on proposals
secretcli tx gov vote <proposal-id> <vote> --from <account name> --ledger